Attaching the Racetrack and Padded Rail – Oval Poker Table

Posted on April 23, 2008 
Filed Under Poker Table Plans

Next, you will want to attach the racetrack to the padded foam. These pieces should fit together according to your marks that you made on them earlier. If necessary, use a long screwdriver as a lever to make the two pieces fit together snugly.

 

Use 3/4″ screws around the entire edge of the racetrack to hold the two pieces together. I used about a dozen screws.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The last step is to attach the newly created piece to the table base. Use 1 ¾” screws to attach these pieces. Make sure to screw the holes as close to the edge of the base as possible. You want the screw to go through the wood in the rail, and not through the top of your racetrack. I have also seen this happen, so please be very careful before drilling.

 

Congrats! You’re done!

Comments

Comments are closed.

Copyright © EZPokerTables.com 2017 All Rights Reserved. Casino | Bodog Poker | Free Bets